It’s time for a lighting revolution! Enjoy enhanced plant control, more branching, denser flowers, and off-the-chart terpenes—all while saving on power! We’re adding four cutting-edge LED fixtures to our HELLION lighting range. Featuring the very latest LED and multi-driver technologies, the HELLION VS3 LEDs represent a whole new level of horticultural light quality, system efficiency, spectral adjustability, and canopy penetration power.

All Hellion VS3 LED fixtures incorporate 3K + 5K white diodes with 660nm Reds to produce a rich baseline full spectrum. Other “full spectrum” LEDs often use just one white diode type mixed with 660nm Reds and stop there. Combining our rich base (3K + 5K + 660nm) with Far-Red and UV-A diodes delivers a superior quality light, driving increased levels of photosynthesis and promoting higher quality crops.

Hellion VS3 LEDs offer growers a revolutionary new level of photomorphogenic control. With separate dimming for veg, bloom and UV, it’s easy to dial in the perfect spectrum for compact and vigorous vegetative growth, reducing stretch during transition, and piling on weight plus colour and flavour in bloom.

Most LED fixtures cut costs by using one single driver to run the entire fixture, inevitably compromising efficiency. The Hellion VS3 LEDs combine THREE separate drivers dedicated to veg, bloom and UV diodes, allowing new levels of system efficiency.

Adjust-A-Wings were never going to let you down in this department! Each light bar sits beneath its own micro-reflector, helping to channel photons towards the canopy with greater precision, focus and radiant intensity. No need for efficiency-sapping lenses.

Iterative control over light intensity has always been at the heart of Adjust-A-Wings’ growing philosophy. By mimicking natural, seasonal cues, plants are more effectively steered indoors to harmoniously and gradually move from one lifecycle phase to another with minimal stress. This all adds up to significant increases in both yield and crop quality.

All HELLION VS3 LEDs are equipped with 3 x independent channels (VEG, BLOOM, UV) for spectral diversity and control. The VEG channel is full-spectrum, rich in Blue. BLOOM is also full-spectrum, rich in Red + Far Red, and UV provides UVA + Near Blue for a fine finish!

Find your favourite mix or try our suggestions:

Gradually increase the intensity of the vegetative channel as your plants develop. Some UV can help to strengthen seedlings and cuttings.

Combining lower bloom with higher UV and high veg can help to reduce unwanted internodal stretch. Try 20% more bloom if some stretch is desirable.

Blue-dominant spectrum helps to keep plants squat and bushy, making them easier to illuminate efficiently during the bloom phase.

Increase bloom after the initial development of flowers. The extra Red and Far-Red promote branching and help to increase flower size and density.

Additional UV during the final few weeks can help to boost flavours, colours and essential oils. Try leaving all channels on full and raising the fixture (5 -10cm / 2 – 4″) if ceiling height permits.

BPF (Bioactive Photon Flux/280 – 800nm) includes PAR+ UV/Near-Blue+ Far-Red/Near IR.